Metal Studs and Fasteners after water, smoke or contamination
Light-gauge steel studs/tracks, galvanized fasteners, ceiling grid and steel connectors do not undergo fungal wood rot, but wet exposure, salts, acidic soot, chemicals or dissimilar-metal contact can promote corrosion and reduce connections/finishes. Wet track can retain water against gypsum facers and paper tape; mold observed at an affected steel wall may be growing on deposited organic debris, adjacent gypsum or insulation, not consuming steel.
What the inspection covers
Record exact member/connector, corrosion texture and extent, loose/coating failure, source and contamination category, possible standing water in tracks, framing attachment and adjoining board/insulation condition. Surface temperature and dew point can explain condensation on cold metal. Avoid reporting a wood-meter '16% steel MC', classifying every rust mark as structural failure or claiming that a wire brush restores unknown structural capacity.
Cleaning, drying and specialist work
After source correction, clean and dry sound serviceable accessible metal components under compatible procedure and restore coatings/fasteners when supported by product/engineer. Corroded perforated/pitted, bent, loose load-bearing or fire-rated assembly members need qualified structural/framing determination and appropriate replacement. Document which finish/board/insulation components actually require removal to access wet tracks and repair source. Estimate work and trade specialization separately.
