HVAC Metal Ducts, Flex Duct and Liner after water, smoke or contamination
Sheet-metal galvanized steel ducts have relatively cleanable nonporous interior surfaces; flexible insulated ducts may contain inner polymer film, helix, outer vapor jacket and fibrous insulation; fiberglass duct board and internally lined metal ducts contain porous fibrous air-contact material. Condensate, system leaks, cooling coil drainage failures, standing water or contaminated air entrainment can wet liners and adjoining ceilings. 'Dark vent dust' does not prove fungal contamination throughout the air handler or duct system.
What the inspection covers
EPA says replacing wetted or visibly moldy fiberglass duct liner or duct material is recommended by EPA/NADCA/NAIMA because ordinary cleaning does not reliably eliminate growth in porous insulation. EPA also cautions against routine sealants and against spraying sealants on wet liner, active growth or debris. Bare accessible metal ducts may be cleaned by a qualified HVAC/duct professional after moisture source assessment; mechanical cleaning, blower/coil/condensate repair or internal duct treatment must not be implied within Serve Xpert's accessible register/grille surface-cleaning scope.
Cleaning, drying and specialist work
Note accessible component names, system operational status, filter loading, condensate pan/line conditions, visible deposits/odor, reported water event versus independently observed moisture and any previous HVAC report. Assess material/fibrous backing and cause with qualified HVAC specialist, de-energize/coordinate appropriately and prevent cross contamination. Retain/clean sound accessible grilles/metal as compatible; refer damp or moldy porous liner, flex duct insulation and inaccessible system internals for professional replacement/evaluation. Do not take a handheld drywall meter percentage on ductboard or claim HEPA-filtering the room decontaminated the system.

